Sharp IV-S30J User Manual page 111

Setting the measurement conditions
REGISTER NO.
16 registers are available for the lead
inspection (Registers 0 to 15).
If you want to set the measurement
conditions for a different register number,
press the SET key to highlight the
register number currently selected. Then
press the up and down arrow keys to
select the register number whose
measurement conditions you want to set.
Press the SET key to confirm your
selection.
REGISTER EXIST
Select whether to register or not.
DTECT PRECISON
Select detection precision. You can
select one of two levels (standard/high),
according to your conditions, the desired
precision level for detection results, and the detection speed.
For details, see page 3-9.
REGISTER NO. ( MEAS OBJECT, LEAD LENGTH)
Register setting conditions are shown for each register number. Circles mean that
"REGISTER NO." has set to "YES."
Æ Setting (display) of items to be inspected
REGISTER NO.
4MEAS OBJECT
LEAD LENGTH
X : No setting
How to set the register conditions
How to enter the REG-COND setting screen
There are three methods for getting to the REG-COND setting screen.
1) On the MEAS CND setting screen, move
the cursor to "
press the SET key. The cursor will move
into the table. Move the cursor to the " "
column and press the SET key.
Note: If you press the SET key in the "X"
column, the setting will be invalid.
2) On the "MEAS CND" setting screen, press
the TRG/BRT key to move the cursor to the
upper function menu. Select the "COND"
item and then select the "REG-COND" item
and press the SET key.
When item "2REGISTER EXIST" has set "YES," a
circle is displayed.
On the "REG COND" screen, when the "7EXTENSION
MEAS" is set to "LEAD-LENGTH," or "BALL-WIDTH," a
circle is displayed.
MEAS OBJECT" and
6-3
MEAS CND SCREEN COND SAVE
1REGISTER NO.
00(0 15)
2REGISTER EXIST YES
3DTECT PRECISION STANDARD
REGISTER NO.
4MEAS OBJECT
LEAD LENGTH
SET=VALUE INPUT ESC=BACK SEL=CHNG IMG TRG=FUNC
MEAS CND SCREEN COND SAVE
1REGISTER NO.
00(0 15)
2REGISTER EXIST YES
3DTECT PRECISION STANDARD
REGISTER NO.
4MEAS OBJECT
LEAD LENGTH
SEL=VALUE INPUT ESC=BACK SEL=CHNG IMG TRG=FUNC
Lead Inspection
F C1 BRT
NO
YES STANDARD
HIGH
F C1 BRT
IMG PRE-PROC
REG-COND
EVALUATION
NUM-CALC
OUT
6