Sharp IV-S30J User Manual page 27

Setting and Operating Outline
1
2 (From the preceding page)
Yes
No
Message display
Yes
Error display
1 (From the preceding page)
No
Positional correction
Yes
Setting the coordinate correction
values (X, Y, )
Executing measurement 1
Yes
Was an error detected?
No
Executing measurement 2
Yes
Was an error detected?
No
Executing measurement 3
Yes
Was an error detected?
No
Executing measurement 4
Was an error detected?
No
No
Displaying the measurement results
No
Display pattern after correction
(*2)
PC calculation
Message display
Yes
(values, decisions etc.)
Pattern display
Yes
Positional correction yes
Yes
To the next page
1-20
[Measurement programs that can be
selected]
- Positional deviation measurement
- Degree of match inspection
- Lead inspection
- Area measurement by binary
conversion
- Counting by binary conversion
- Object identification by binary
conversion
- Point measurement
- Multiple position measurement
- Multiple degree of match inspection
The window coordinates are
corrected within the range set for
each type of measurement,
based on the correction value
determined in the steps marked with
*2.
No
Display pattern when setting