Sharp IV-S30J User Manual page 65

Setting Measurement Conditions
Setting method
There are two ways to get to the evaluation condition setting screen.
1) Select "CND" in the upper function menu on
the MEAS CND (or REG COND) screen and
press the SET key. Select "EVALUATION" on
the pop up menu to go to the "EVALUAT
3
COND" screen.
2) Move the cursor to the "EVALUATION COND"
item on the Menu tree screen and press the
SET key.
MEAS CND SCREEN COND SAVE
1DTECT PRECISION STANDARD
2REGISTER NO.
0(0~7)
3MODE
1P-SCH
4DTECT ANGL
–15¡
5ANGLE UNIT
10
REGISTER NO.
6MDL 0
7MDL 1
SET=VALUE INPUT ESC=BACK SEL=CHNG IMG TRG=FUNC
SELECT OBJECT TYPE COND
OBJECT TYPE COND
TYPE00
TYPE RUN COND
IMAGE-ADJ
MEA-CND(CAMERA1)
MEAS0(POSI-DEVIATION)
IMG PRE-PROC
MEAS CND
REG-COND(S)
REG-COND(E)
EVALUATION COND
DISTANCE&ANGLE COND
NUM-CALC
OUT-COND
POSI-CORRECT
MEAS(NEW)
MEA-CND(CAMERA2)
FINAL NUM.CALC
FINAL OUTPUT COND
OBJ-TYPE I/O
SET=TO NEXT SUB-MENU ESC=BACK SEL=CHNG IMG TRG=POPUP
3-18
F C1 BRT
IMG PRE-PROC
REG-COND(S)
REG-COND(E)
POSITION CORRECTION
EVALUATION
DST&ANGL
NUM-CALC
OUT
F C1 BRT
1REGISTER NO.
2CONDITION SET
3X COORD.
(BDL0)
4Y COORD.
(MDL0)
5x DEVIATE
(MDL0)
6y DEVIATE
(MDL0)
7MATCH LVL (MDL0)
8ANGULAR DEVIATE
9X COORD.
(MDL1)
0Y COORD.
(MDL1)
qx DEVIATE
(MDL1)
wy DEVIATE
(MDL1)
eMATCH LVL (MDL1)
rTEST