Positional Deviation Measurement - Sharp IV-S30J User Manual

Positional Deviation Measurement

Register a reference image
After setting the reference image area, store an
image in the controller as a reference image.
Select "
down arrow keys and select "REG" from the
popup menu.
4
C O N T R
c ( o t n a r t s
R E G ( e r
D S I P d (
SEARCH ARE
Specify the search area (inside the dotted lines)
on the "
same procedures used for setting the reference
image area.
If you are selecting a 2-point search, also set the
points the same way as for MDL1.
An example of storing
- This is an example of a 2-point search when the detection shape is a rectangle.
Reference image
Note: When setting the horizontal and vertical lines, specify the line length as follows:
The reference image must shorter than the search area lines.
REFERENCE IMG" using the up/
A S T S R C H A t f r e c h a n g
s e a c r ) h i w h t h t e m o
g s i e t ) r S o t e r h t e c
S e e l t c a n y
s i p a l ) y u p d / o w n l / f e
d s i p a l y e d n i
SEARCH ARE (MDL0)" line, using the
Model 0
(Model 0)
Search area
(Model 0)
RECTANGLE
MDL 0
1
2
3MOVE
4REFERENCE IMG
SET=MOVE ESC=BACK SEL=CHNG IMG TRG=FUNC
n i g o t a g a r y s e a c r , h a u o t
t s e f a u t e r s ( m a i x m u m c o
r u e r n y l t d s i p a l y e d i m a g e a
o n e f o h t e e r g s i e t e r d e r e f
r / t g i t h r a o r w k e y , s h t e s e e l
h t e o l w e r r g i t h f o h t e c s e r
REG COND
1
2MEAS SHAPE (MDL0)
3REFIMG ARE (MDL0)
4SEARCH ARE (MDL0)
SEL=VALUE INPUT ESC=BACK SEL=CHNG IMG TRG=FUNC
4-6
RESET RETURN
CONTRAST SRCH
REG
DISP
m a c i t a y l l s e a c r h f r o h t e a
t n a r s ) t n i h t e c a p u t e r d i m a
s a e r e f e r n c e i m a g . e
e r n c e i m a g e s u s n i g h t e
c e t d e r e f e r n c e i m a g e w l l i
e . n
SCREEN COND SAVE DETAIL
0(0 7)
RECTANGLE
SET 224.208) (287.271
SET 216.200) (295.279
Search area
Object to measure
Model 1
Reference image (model 1)
Search area (model 1)
F C1 BRT
X:224 Y:208
e r a
g . e
b e
F C1 BRT