Configuring Source Ipv6 Addresses Of Mld Queries; Configuring The Function Of Dropping Unknown Ipv6 Multicast Data - H3C S5500-SI Series Manual

Operation Manual – Multicast Protocol
H3C S5500-SI Series Ethernet Switches
Configure
last-member
interval
Caution:
In the configuration, make sure that the MLD general query interval is larger than the
maximum response time for MLD general queries.

2.5.4 Configuring Source IPv6 Addresses of MLD Queries

Follow these steps to configure source IPv6 addresses of MLD queries:
To do...
Enter system view
Enter VLAN view
Configure the source
IPv6 address of MLD
general queries
Configure the source
IPv6 address of MLD
group-specific
queries
Caution:
The source IPv6 address of MLD query messages may affect MLD querier selection
within the segment.

2.5.5 Configuring the Function of Dropping Unknown IPv6 Multicast Data

Unknown IPv6 multicast data refers to IPv6 multicast data whose forwarding entries do
not exist in the corresponding multicast forwarding table.
Follow these steps to configure the function of dropping unknown IPv6 multicast data in
a VLAN:
To do... Use the command...
the MLD mld-snooping
query
last-member-query-inter
val interval
system-view
vlan vlan-id
mld-snooping general-query
source-ip { current-interface |
ipv6-address }
mld-snooping special-query
source-ip { current-interface |
ipv6-address }
Chapter 2 MLD Snooping Configuration
Use the command...
2-14
Remarks
Optional
1 second by default
Remarks
—
—
Optional
fe80::02ff:ffff:fe00:0001
by default
Optional
ffe80::02ff:ffff:fe00:0001
by default