Tone Parameters; Telephony Tone Parameters - AudioCodes E-SBC User Manual

CHAPTER 68 Configuration Parameters Reference
Parameter
is-cas-sndhook-flsh
[CASSendHookFlash]

Tone Parameters

This subsection describes the device's tone parameters.

Telephony Tone Parameters

The telephony tone parameters are described in the table below.
'Maximum simultaneous streaming
calls'
max-streaming-calls
[MaxStreamingCalls]
■ To include the P-Asserted-Identity header in outgoing SIP
UPDATE messages, set the AssertedIDMode parameter to
Add P-Asserted-Identity.
Enables sending Wink signal toward CAS trunks.
■ [0] = Disable (default)
■ [1] = Enable
If the device receives a mid-call SIP INFO message with
flashhook event body (as shown below) and the parameter is set
to 1, the device generates a wink signal toward the CAS trunk.
The CAS wink signal is done by changing the A bit from 1 to 0,
and then back to 1 for 450 msec.
INFO sip:4505656002@192.168.13.40:5060
SIP/2.0
Via: SIP/2.0/UDP 192.168.13.2:5060
From: <sip:06@192.168.13.2:5060>
To:
<sip:4505656002@192.168.13.40:5060>;tag=13287
8796-1040067870294
Call-ID: 0010-0016-D69A7DA8-1@192.168.13.2
CSeq:2 INFO
Content-Type: application/broadsoft
Content-Length: 17
event flashhook
Note: The parameter is applicable only to T1 CAS protocols.
Table 68-55:Tone Parameters
Parameter
Mediant 1000 Gateway & E-SBC | User's Manual
Description
Description
Defines the maximum number of concurrent call parties
that have been placed on hold to which the device can
play Music on Hold (MoH) that originates from an
external media player.
The maximum is 20. The default is 0.
For more information, see
External Audio Source on page 648.
Note:
■ The parameter is applicable only to FXS interfaces.
■ Each FXS port supports up to 20 concurrent MoH
sessions.
- 1293 -
Configuring MoH from