Table of Contents
Advertisement
Changing the Interface Parameters
11 — KIR Test Pattern
KIR is the Kyocera original smoothing function. This test pattern shows
the effect of the KIR (Kyocera Image Refinement) system.
The printer is equipped with parallel and USB interfaces. In addition, it is
possible to add an optional serial interface to the printer. Various printing
environment parameters such as the default emulation can be changed
independently of the interface by using the printer's menu selection
system. First, select the interface to which the changes apply using the
procedure described below.
The interface selection described below does not select which interface
data will be received from. The printer automatically selects an interface
from which data is received.
Note
Selecting a Parallel Interface Mode
The parallel interface mode of this printer supports a bi-directional/high-
speed mode. Normally, this interface is used in the Auto mode as default.
For details, see
the printer. Only after you do this does the change take effect.
1
Press the MENU key.
2
Press the
interface names shown below appears, indicating the current
interface.
Parallel (default)
USB
Serial (option)
Option (with a network interface card installed)
3
Press the ENTER key. A blinking question mark (?) appears.
Interface
? Parallel
If Parallel is not displayed, press the
appears.
If you want to abandon this procedure, press the CANCEL key. The
interface remains unchanged.
4
Press the ENTER key again.
Appendix C
Appendix C
Appendix C
Appendix C
. After selecting an interface, reset or restart
or
key until Interface > appears. One of the
1-17
Using the Operator Panel
or
key until Parallel
Advertisement
Table of Contents
