Switching To Setting Mode - Omron S8AS User Manual

Switching to Setting Mode

4-4

Switching to Setting Mode

Selecting the Operating Mode from the Mode Selection Menu
Branch output number 1 is lit.
60
When the S8AS is started, it will enter Run Mode. If the power was turned
OFF while the S8AS was in Test Mode, it will start in Test Mode the next time
it is started.
To switch to Setting Mode from Run Mode or Test Mode, select Setting Mode
from the Mode Selection Menu, as shown below.
The Mode Selection Menu can be displayed by pressing both the Up (SEL)
Key ( ) and Down (CH) Key (
If the S8AS is switched to the Mode Selection Menu from Run Mode,
RUN (select Run Mode) will be displayed.
r u n
Press the
When the
played.
s e t
If the
The initial display for Setting Mode will be displayed.
c - V
The initial Setting Mode display is the abnormal current tripping threshold (C-
V) for branch output 1.
The branch output that was most recently modified will be the current branch
output regardless of the operating mode.
Once the S8AS is switched to Setting Mode, it will not return to Run Mode
automatically.
(To return to Mode Selection Menu, press the
neously for 3 seconds again.)
For details on setting parameters in Setting Mode, refer to the following pages.
) simultaneously for 3 seconds.
Key.
Key is pressed, SET (select Setting Mode) will be dis-
Key is pressed, the S8AS will switch to Setting Mode.
The "A" unit indicator will
be lit when a current is
displayed.
Section 4-4
and Keys simulta-