Omron S8AS User Manual page 138

Glossary
Symbol Seven-segment
run
RUN
set
SET
swt
SWT
tmp
TMP
tgs
TGS
trg
TRG
tst
TST
uno
UNO
ups
UPS
usu
USU
v-u
V-U
120
display
Run is an option in the Mode Selection Menu which is selected
when entering Run Mode.
SET is an abbreviation for "setting."
It is an option in the Mode Selection Menu that is selected when
entering Setting Mode.
SWT is an abbreviation for "send waiting time."
Sets the communications waiting time for RS-485 communications.
TMP is an abbreviation for "temperature."
The Over-temperature Output (TMP) photoswitch output will turn
OFF if the temperature exceeds the set value.
Trigger-Sense
Sets the tripping input detection method for TRG. There are two
types of detection methods, EGE and LVL.
TRG is an abbreviation of "trigger."
Determines for each branch output whether it can be cut off using
an external input signal.
TST is an abbreviation for "test."
It is an option in the Mode Selection Menu that is selected when
entering Test Mode.
UNO is an abbreviation for "unit number"
Sets the unit number for RS-485 communications.
UPS is an abbreviation of "startup sequence."
It sets the connection delay time for each branch output. Setting
range: 0.0 to 99.9s
USU is an abbreviation for "usually."
It is a cutoff type (C-T) for abnormal current tripping. It trips within
100 ms.
V-U is an abbreviation for "voltage under."
It sets the undervoltage detection threshold value. If the output
voltage falls below this set value, the seven-segment display
shows the error code A21 and the undervoltage detection output
(LOW) photoswitch output turns OFF.
Meaning
Appendix A
Page
57
57, 60
75
50, 65
69
17, 50,
68
57
70
66
62
63