Omron S8AS User Manual page 67

Power Supply and Input/Output Wiring
Branch
circuit 1
Wiring the Terminal Block
Connectors
■
Wiring the Branch Output Connector
240 W
Branch
output 1
+
Branch
+
output 1
−
Branch
circuit 1
−
480 W
Branch
Branch
Branch
output 2
output 1 output 3
+
+
Branch Branch
Branch
output 2 output 3
output 1
+
−
−
−
Note You may connect the positive terminals or the negative terminals of the same
branch output in parallel, but do not connect them with other branch outputs.
The lock screws on both sides of the branch output connector are loose when
shipped from the factory. Tighten them securely after you complete the wiring.
Use a solid or stranded wire. If you are using stranded wire, twist the end
before connecting it to make a clean connection.
• Strip the wire for approximately 10 mm from the end.
• Insert a flat-blade screwdriver into the release button to release the lock.
Insert the wire into the round hole, and then release the button to lock the
wire in place.
Branch
Branch
Branch
output 4
output 2 output 3
+ +
+
Branch Branch
Branch Branch
output 2 output 4 output 5
output 3
−
− −
Branch Branch
Branch Branch
output 5 output 7
output 4 output 6
+ + + +
Branch Branch
Branch Branch
output 4 output 6
output 5 output 7
− − −
−
Release Button
10 mm
Branch
Branch
output 6
output 5
+
+
+
Branch Branch
output 6
circuit 6
−
−
Branch
output 8
+
+
Branch
output 8
Branch
− −
circuit 8
Branch output
common (−)
Section 3-3
−
Branch output common (−)
+
−
Branch output common (−)
49