Operation Command - Omron S8AS User Manual

Operation Command

6-8

Operation Command

This service performs operation command processing.
■ Service Request PDU
MRC SRC
3 0 0 5
2 2
■
Service Response PDU
MRC SRC
3 0 0 5
2 2
(1) Command Codes and Related Information
Command
code
00
01
02
03
04
10
Note (1) If a process is executed for all of the branch outputs and cannot be per-
formed on one or more of them, it will still be performed on the other out-
puts. In this case, a normal response will be returned, so check the
controller status display to confirm whether or not the outputs were actu-
ally connected or disconnected.
(2) After parameter initialization has been successfully completed, a normal
response will be returned and then a software reset will be performed.
(3) The response to parameter initialization will be returned immediately
even if a send wait time is specified.
Command
Related
Code
Info.
2 2
Response Code
4
Command content
Immediately connect Each bit corresponds to a branch output.
(Multiple branch outputs can be specified.)
01: Branch output 1
02: Branch output 2
04: Branch output 3
08: Branch output 4
Immediately discon- Each bit corresponds to a branch output.
nect (Cut off) (Multiple branch outputs can be specified.)
01: Branch output 1
02: Branch output 2
04: Branch output 3
08: Branch output 4
Startup Always set to 00.
Shutdown Always set to 00.
Reset switch Always set to 00.
Clear peak output Each bit corresponds to a branch output.
current (Multiple branch outputs can be specified.)
01: Branch output 1
02: Branch output 2
04: Branch output 3
08: Branch output 4
Section 6-8
Related Information
10: Branch output 5
20: Branch output 6
40: Branch output 7
80: Branch output 8
10: Branch output 5
20: Branch output 6
40: Branch output 7
80: Branch output 8
10: Branch output 5
20: Branch output 6
40: Branch output 7
80: Branch output 8
107