Starting Setup Utility - NEC Express5800 User Manual

Starting SETUP Utility

When you turn on the server, the NEC logo appears first. (The POST (Power On Self-Test) screen
might appear first, depending on the SETUP settings.)
The following message then appears at bottom left of the screen.
Message displayed when the NEC logo appears:
Press <F2> to enter SETUP or Press <F12> to Network
Message displayed when the POST screen appears:
Press <F2> to enter SETUP <F10> Boot menu <F12> to boot from
Network
If you press F2 while the above message is displayed, the SETUP utility will launch and its main
menu will be displayed.
If you have previously set a password with the BIOS Setup utility, the password entry screen
appears. Enter the password.
Enter password:[
Up to three password entries will be accepted. If you fail to enter the password correctly for three
consecutive times, the server halts. (You can no longer proceed.) Power off the server.
NOTE:
Administrator and User. With the Administrator password, you can
view and change all system parameters. With the User password,
system parameters available for viewing and changing are limited.
The server is provided with two levels of password:
]
Configuring Your Server 4-3