NEC Express5800 User Manual page 167

Setting WOL
Refer to the following procedure to enable WOL.
1.
Start Device Manager.
2.
Point to [Network adapters] and double click [Intel(R) 82547L Gigabit Network
Connection] to open the adapter [Properties].
3.
Click [Power Management] tab and change setting in [Wake On LAN] according to the
following list.
Setting item
"Wake On Directed Packet"
"Wake On Magic Packet"
"Wake on Magic Packet from power off state"
"Wake on Link"
IMPORTANT: DirectedPacket
Shutdown state even "Wake On Directed Packet" is setting "ON".
Only on Sleep or Hibernate state will wake up by a DirectedPacket.
(*1) Packet with the Ethernet address of the adapter in ethernet header
or Packet with an IP address assigned to the adapter in IP header.
NOTES:
[Power Saver Options] setting is not necessary to change.
Above setting will be maintained until manually resetting are
executed.
IMPORTANT: The parameters of [Wake On LAN] will not exist, if
the network ports are not available for WOL.
4.
Click [OK].
5.
Restart the system.
Installing the Operating System with Express Setup 5-53
(*1)
will not wake up the system on
Change setting
ON or OFF
ON
ON
OFF