NEC Express5800 User Manual page 375

Create from the menu which appears when running NEC Express5800 Server with
NEC EXPRESSBUILDER
If you have only NEC Express5800 server to create Windows Server 2008 R2 OEM-Disk for
EXPRESSBUILDER, use this procedure.
If Windows Server 2008 R2 can be operated on NEC Express5800 Server, you can use the other
procedure described later.
Follow the steps below.
1.
Prepare one Flash FDD or 3.5-inch floppy disk.
2.
Turn on your NEC Express5800 server.
3.
Insert the NEC EXPRESSBUILDER DVD into the optical disk drive of the server.
4.
Press the RESET switch or press Ctrl, Alt and Delete to reboot the server. (You may also
turn off and then on again to reboot the server.)
The system will boot from the DVD and NEC EXPRESSBUILDER starts.
5.
Select [Create the OEM-Disk for Windows] from [Tools Menu] step.
6.
Select [Create a Windows Server 2008 R2 OEM-Disk for EXPRESSBUILDER] at
[Create OEM-Disk] and click [Perform].
7.
Windows Server 2008 R2 OEM-Disk for EXPRESSBUILDER will be created.
Write-protect and attach a label, then keep it safely.
NOTE:
write-protected.
Cancel write-protected state.
If you have already cancelled write-protected state, connect the floppy
disk drive again.
If the following message is displayed, the floppy disk is
Installing Windows Server 2008 R2 D-7