NEC Express5800 User Manual page 76

4-10 Configuring Your Server
Main
Option
System Time
System Date
Hard Disk Pre-Delay
SATA Port 0
SATA Port 1
SATA Port 2
SATA Port 3
SATA Port 4
SATA Port 5
Processor Settings
Language
IMPORTANT:
operation if any of the following conditions is applicable.
After carriage of device
After storage of device
After the device is entered into the pause state under the
environmental condition enduring device operation (temperature:
10°C - 35°C, humidity: 20% - 80%)
Check the system clock at the rough rate of once per month. When the
system clock is installed in a system requiring high time precision, it is
recommended to use a time server (NTP server).
If the system clock is remarkably delayed or advanced as the passage of
time in spite of adjustment, contact your service representative for
maintenance.
Parameter
HH:MM:SS
MM/DD/YYYY
[Disabled]
3 seconds
6 seconds
9 seconds
12 seconds
15 seconds
21 seconds
30 seconds
–
–
[English (US)]
Français
Deutsch
Español
Italiano
Check and adjust the system clock before the
Description
Set the system time.
Set the system date.
When accessing the IDE device
for the first time during POST,
the system waits for the
specified time until the device
becomes ready.
Shows the information on the
device connected to each
channel on the submenu. The
settings of some items may be
changed. However, leave the
items as they are at the
shipment.
Shows the processor settings
submenu.
Select which language BIOS
displays.
Your Setting
[ ]: Factory-set