NEC Express5800 User Manual page 95

1.
See the section "Preparing for Installation and Removal" as described in Chapter 9 of this
guide to prepare.
2.
Remove the side cover (see Chapter 9).
3.
Locate the position of the RAID configuration jumper on the mother board as shown
below.
NOTES:
The factory setting of the RAID configuration jumper switch
depends on your order.
If you are using an Optional RAID Controller, set the RAID
configuration jumper switch to the position "non-RAID".
4.
Install the side cover removed in Step 2.
Then, configure the RAID system by using the LSI Software RAID Configuration Utility.
Mother board
Configuring Your Server 4-29
RAID configuration jumper switch
(SWRAID)
non-RAID
RAID