Inch Device - NEC Express5800 User Manual

5.25-inch Device

Installation
Install a file device in the following procedure. This section describes how to install an optional
SCSI device, for an example:
1.
Provide the proper setting for the device.
See the table below for the settings of the devices which can be installed in the device bay.
Device
SCSI device
* If the terminator is not attached to the optional internal SCSI cable, set the termination
resistance to ON. When installing a SCSI device, make sure that the settings of the
installed SCSI device are not the same as those of an external SCSI device with the
same SCSI ID connected to the controller.
2.
See the section "Preparing for Installation and Removal" described earlier to prepare.
3.
Remove the side cover and front bezel as described earlier in this chapter.
4.
Remove the EMI cover for the 5.25-inch device slot.
Settings
Termination resistance OFF*
Upgrading Your Server 9-51