NEC Express5800 User Manual page 82

4-16 Configuring Your Server
Security
Press Enter on "Set Supervisor Password" or "Set User Password," to display the password entry
screen.
Enter the passwords on the dialog box.
IMPORTANT:
User password can be set only when Supervisor password is already
set.
Set the passwords only after OS is installed.
If you forget the passwords, contact your service representative.
Option Parameter
User Clear
Password Is Set
Supervisor Clear
Password Is Set
Set Supervisor Up to eight
Password alphanumerics
Set User Up to eight
Password alphanumerics
Password on [Disabled]
boot Enabled
Fixed disk boot [Normal]
sector Write Protect
Disable USB [Disabled]
Port Front
Rear
Internal
Front + Rear
Front + Internal
Rear + Internal
Front + Rear + Internal
Description
Indicates the user password setting
status.
Indicates the supervisor password
setting status.
Press Enter to display the
supervisor password entry screen.
This password enables all the
SETUP menus to be accessed. This
setting can be done only on login
with the password input of
"Supervisor" at start of SETUP.
Press Enter to display the user
password entry screen. For this
password, accessing to the SETUP
menu is restricted.
This setting can be done only on
login with the password input of
"Supervisor" at start of SETUP.
Specify whether the passwords are
entered or not on booting. At first,
the supervisor password must be
set. If the supervisor password is set
and this option is disabled, BIOS
determines that a user is booting.
Specify whether to permit writing
into boot sector of the IDE hard disk
drive or not. The server does not
support IDE hard disk drive.
Select the USB port to be disabled
or enabled.
Your Setting
[ ]: Factory-set