NEC Express5800 User Manual page 323

Attaching and removing the N8103-125 additional battery
Attaching the battery
1.
Attach the connector board and battery control cable supplied with the N8103-125
additional battery to the RAID controller. Refer to the user's guide supplied with the
additional battery for how to attach the connector board and cable to the RAID controller.
2.
Prepare the server as shown on Page 9-4.
3.
Remove the side cover as shown on Page 9-5.
4.
Remove the anchor plate attached to the bottom of the hard disk drive cage.
Remove the screw.
5.
Remove the three screws that attach the battery pack to the bracket and attach the battery
pack to the plate removed in step 4.
Upgrading Your Server 9-33
Slide out the plate in
the direction shown.