Interface Cables; Addition Of Hard Disk Drive - NEC Express5800 User Manual

10-2 Internal Cabling Diagrams

INTERFACE CABLES

This section describes the connections of the interface cables.

Addition of Hard Disk Drive

The connection required when a hard disk drive is added is described below.
Installation of SATA Disks and SSDs Connected to On-board SATA Controller
If the serial ATA (SATA) hard disk drives and SSDs are added, connect the cables as shown in the
figure below.
Fill the hard disk drive cage with the hard disk drives from the bottom to top.
Power
Unit
Mother board
SATA cable for even-numbered port
SATA cable for odd-numbered port
SATA0 SATA1
SATA2 SATA3
SATA4 SATA5
Optical disk drive
5.25-inch device bay
4th hard disk drive
3rd hard disk drive
2nd hard disk drive
1st hard disk drive