Setup Team; Setting Wol - NEC Express5800 User Manual

G-20 Installing Windows Server 2003

Setup Team

See Chapter 5, "Setup Team" for re-setting the Team.

Setting WOL

Refer to the following procedure to enable WOL.
When PROSet is not installed
1.
Start Device Manager.
2.
Point to [Network adapters] and double click [Intel(R) 82547L Gigabit Network
Connection] to open the adapter [Properties].
3.
Click [Power Management] tab and change setting in [Wake On LAN] according to the
following list.
Setting item
"Allow the computer to turn off this device to save power"
"Allow this device to bring the computer out of standby"
IMPORTANT:
■ Set "Allow this device to bring..." to "ON", WOL by
DirectedPacket
state.
■ WOL by DirectedPacket is not available on Hibernate and
Shutdown state.
(*1) Packet with the Ethernet address of the adapter in ethernet header
or Packet with an IP address assigned to the adapter in IP header.
4.
Click [Advanced] tab and point to [Enable PME].
5.
Set the "Enable" in [Value].
6.
Click [OK].
7.
Restart the system
(*1)
or MagicPacket will be available on Standby
Change setting
ON
ON or OFF