Troubleshooting - NEC Express5800 User Manual

Error
Error message
code
0615 Com B configuration changed
0616 Com B config. error - device
disabled
0B00 WDT timeout occurred at previous
boot in POST.
0B01 WDT timeout occurred at previous
boot in OS boot.
0B02 WDT timeout occurred at previous
boot in OS running.
0B28 Unsupported CPU detect on CPU
Slot
0B60 DIMM group #1 has been disabled
0B61 DIMM group #2 has been disabled
0B62 DIMM group #3 has been disabled
0B63 DIMM group #4 has been disabled
0B6F DIMM group with error is enabled
Mismatched FAN control Mode
0B7E
setting. Please set the FAN control
mode on BIOS SETUP.
0BB0 SMBIOS - SROM data read error.
0BB1 SMBIOS - data checksum bad.
8151 Password Cleared By Jumper
8800 PECI - Communication Error
9000 PCI Slot#1 PCIE Link Training
Error.
9001 PCI Slot#2 PCIE Link Training
Error.
9002 PCI Slot#3 PCIE Link Training
Error.
- Expansion ROM not initialized - PCI
Mass Storage Controller in slot xx
Recommended Action
Check if COM B is properly configured.
Reboot (reset) the server. If the server starts
normally, confirm the DMI log.
Contact your service representative.
Contact your service representative.
Run BIOS SETUP and provide setting again.
Contact your service representative.
Power off the server, then change the password clear
jumper switch to its original position.
Contact your service representative.
Remove the PCI card from the slot that shows an
error, then install the PCI card again. If the same
error persists, contact your service representative.
If the hard disk drive connected to RAID Controller or
LAN board (for network boot) does not contain any
OS, disable Option ROM Scan for that PCI slot.

Troubleshooting 8-7