NEC Express5800 User Manual page 200

5-86 Installing the Operating System with Express Setup
4.
Specify "Complete memory dump" and modify [Dump file:] in the [Write debugging
information] group box.
e.g. Write the debug information in D drive write the file name "MEMORY.DMP".
D:\MEMORY.DMP
5.
Click [Settings] on the [Performance] group box.
The [Performance Options] window appears.
6.
Click [Advanced] tab on the [Performance Options] window.
7.
Click [Change] on the [Virtual memory] group box.
8.
Modify [Initial Size] in the [Paging file size for selected drive] box to the value larger than
the value of [Recommended] in the [Total paging file size for all drives], and click [Set].
IMPORTANT:
The above-mentioned paging file size is recommended for
collecting debug information (memory dump). The paging file
with initial size large enough to store the dump file in the boot
drive is required.
Correct debug information might not be able to be collected due to
virtual memory shortage when the paging file is insufficient, so set
an enough size of the paging file with the entire system.
For more information on "Recommended" value, see "About the
System Partition Size" described earlier.
In case the memory is expanded, re-specify the paging file to suit
the new memory size.
9.
Click [OK].
The message to restart the system may appear according to the modified specification. In
such case, follow the message to restart the system.