Configuring Your Server - NEC Express5800 User Manual

4-18 Configuring Your Server

The table below shows the operation when the AC power to the server is turn off once and then on
again, depending on the setting of "AC LINK."
System status before AC power off
Operating
Aborting (DC power being off also)
Forced shutdown
* Press the POWER/SLEEP switch continuously for four seconds or longer. This forcibly
turns off the power. After this operation, the system does not turn on the power even
though the AC-LINK setting is set to Power On.
IMPORTANT:
To power on the server from the UPS (Uninterruptible Power
Supply), select [Server] - [AC Link] - [Power On].
If the server is connected to the UPS, set at least 10 seconds delay in
the power-on schedule.
Setting of AC LINK
Stay Off Last State
Off On
Off Off
Off Off
Power On
On
On
Off