Starting Setup Utility - NEC BladeServer Express5800 Series User Manual
Hide thumbs
Also See for BladeServer Express5800 Series:
- User manual (574 pages) ,
- Maintenance manual (238 pages) ,
- Installation manual (75 pages)
Table of Contents
Advertisement
4-2 Configuring Your Server
Starting SETUP Utility
Powering on the CPU blade starts POST (Power On Self-Test) and displays its check results. If the
NEC logo is displayed, press Esc.
After a while, the following message appears at the bottom left of the screen:
Press <F2> to enter SETUP
Press F2 to start the SETUP utility and display its Main menu.
If you have previously set a password with the SETUP utility, the password entry screen appears.
Enter the password.
Enter password:[
Up to three password entries will be accepted. Three incorrect password entries disable the system.
In this case, turn off the power and wait about 30 seconds before turning it on again.
NOTE:
Supervisor and User. With the Supervisor password, you can view and
change all system parameters. With the User password, the system
parameters you can view and change are limited.
The CPU blade is provided with two levels of password:
]
Advertisement
Table of Contents
