Dimm - NEC Express5800 User Manual

DIMM

The DIMM (Dual Inline Memory Module) is installed in a DIMM socket on the mother board
installed in the server.
The mother board contains four sockets in which DIMMs are installed. A 1GB DIMM is factory
installed in DIMM #1. (The DIMMs factory installed may be replaced.)
Up to 16GB (4GB × 4) of memory can be added.
IMPORTANT:
The DIMM is easily affected by static electricity. Make sure to wear
the wrist strap (an arm belt or anti-static glove), and discharge static
electricity from your body before handling the DIMM. Do not make
bare hands contact with terminals and components on the DIMM. In
addition, do not put the DIMM on a non-anti-static desk directly.
See "Static Precautions" for details of the static electricity.
Do not use any DIMM not approved by NEC. If an unapproved
third party's DIMM is installed in the server, not only the DIMM but
also the server itself may be defected. You will be charged by any
repair of a malfunction or defect caused by such a device within the
warranty period.
The mother board in your server supports the single channel memory configuration and dual
channel memory configuration.
The dual channel memory configuration provides increased performance over the single channel
memory configuration
Upgrading Your Server 9-45
DIMM #2
DIMM #4
DIMM #1
DIMM #3