NEC Express5800 User Manual page 113

The following describe the clearing procedure.
Do not disassemble, repair, or alter the server.
Never attempt to disassemble, repair, or alter the server on any occasion other
than described in this manual. Failure to follow this instruction may cause an
electric shock or fire as well as malfunctions of the server.
Clearing CMOS Data
1.
See the section "Preparing for Installation and Removal" as described in Chapter 9 of this
guide to prepare.
2.
Remove the side cover (see Chapter 9).
3.
Install the jumper on position 2-3 (CMOS clear) of the jumper block.
See the figure on the previous page to find the location of this jumper.
4.
After five seconds later, reinstall the jumper to original position (1-2).
5.
Reinstall the side cover and connect the interface cables.
6.
Connect the power cord to the server and then turn on the power.
7.
Press F2 at the prompt to run the BIOS SETUP utility, and select "Load Setup Default" at
the Exit menu.
Configuring Your Server 4-47
WARNING