1.9.8
Checking the Hole-Punching Positions (FN-109 only)
Select
a
finishing
mode.
SELECT
POSITION
to
Select
hole
punching
positon
Rev. 11..0.0/03.01
1. Unplug the power cord, and then turn off the
copier.
2. Load A4-size paper (in landscape orientation)
into tray 1
3. Touch "Finishing."
Mixed Orig Detection
Memory Free
4. Touch "Hole-Punch" so that its background
changes to black.
Use
the
Memory Free
5. Press the Start key.
6. Fold the paper that is fed out in half, and
check that the punched holes are aligned.
Standard position: ±2 mm
If the punched holes are not at their standard
positions, adjust the hole-punching position.
I-57
Di251/Di351