Minolta Di251 Service Manual page 185

No. Part Name
1 Original Glass
2 Right IR Cover
3 Upper Rear
Inside Cover
4 Lower Rear
Inside Cover
5 Fusing Unit
6 Front Inside
Cover
7 Toner Bottle
Cover
8
Duplex Unit ( 2)
9 Side Cover
10 Manual Bypass
Tray
11 Fixed Paper Size
Cassette Side
Cover ( 1)
12 Front Cover
13 Multi Purpose
Cassette
14 Fixed Paper Size
Cassette ( 1)
15 Upper Cover
16 Control Panel
17 Upper Front
Cover
18 Left Front Upper
Cover
19 Front Holding
Bracket
20 Upper Left Cover
21 Left Hinge Cover
22 Rear Holding
Bracket
23 Right Hinge
Cover
24 Original Cover
25 Left IR Cover
26 Left Rear IR
Cover
27 Exit Lower Cover
28 Left Cover
Remove no. 17. Remove two holding brackets.
Remove two screws that secure the Right IR Cover.
Unhook one tab and remove the Upper Rear Inside Cover.
Remove no. 13. Remove no. 3.
the PWB-A Board Assy.
Cover of no. 5. Remove three screws that secure the Rear Inside Cover.
For removal of the MFB2 Board Assy and PWB-A Board Assy, see steps 2
through 11 of "(1) Removal of the PH Unit" of "2-5. OPTICAL SECTION."
D-27
Remove no. 11. Remove no. 5.
Front Inside Cover.
Open the Toner Bottle Cover.
Toner Bottle Cover and remove the cover.
Remove no. 28. Remove two connectors.
secure the Duplex Unit.
—
Remove no. 28. Unplug one connector.
secure the Manual Bypass Tray.
Open the Side Cover.
time, pull the rear side out of the frame.
Slide out no. 12. Remove three screws that secure the Front Cover.
Slide out the Multi Purpose Cassette.
out the cassette.
Slide out the Fixed Paper Size Cassette.
right and left rails, pull out the cassette.
Remove two screws that secure the Upper Cover.
Remove no. 11. Remove no. 17.
Remove five screws that secure the Control Panel.
Remove no. 11. Remove no. 17.
screws that secure the Upper Front Cover.
Remove no. 17. Remove two screws that secure the Left Front Upper
Cover.
Remove two screw caps.
ing Bracket.
Remove no. 17. Remove two screws that secure the Upper Left Cover.
Remove one screw that secures the Hinge Cover.
Remove nos. 19 and 21.
ing Bracket.
Remove one screw that secures the Hinge Cover.
Pull the Original Cover straight upward.
Remove two screws that secure the Left IR Cover.
Remove one screw that secure the Left Rear IR Cover.
Remove the Fusing Unit.
Exit Lower Cover and remove the cover.
Remove four screws that secure the Left Cover.
Removal Procedure
Remove the MFB2 Board.
Open the Manual Bypass Tray.
Remove two screws that secure the
Unhook the dowels at four places of the
Remove three screws that
Slide the Side Cover to the front and, at the same
Pushing the tab on the right rail, pull
Pushing the tabs on both the
Remove no. 16.
Remove no. 16.
Remove two screws that secure the Front Hold-
Remove two screws that secure the Rear Hold-
Remove no. 4. Unhook the two tabs of the
Remove
Open the Exit
Remove two screws that
Remove no. 15.
Remove six