Rev. 11..0.0/03.01
5. Install the Bracket with care not to wedge the
Harness connected.
Accessories:
Screw .................. 2
Make sure that the tabs on the base plate of the
Paper Feed Unit fit into the slits in the bottom of
the Bracket.
6. Accessing through the hole in the Bracket,
connect the connector (white portion) of
Power Supply Harness 1 (with a core).
7. Connect the connector (black portion) of
Power Supply Harness 1 (with a core) to the
connector (black portion) of Power Supply
Harness 2 (without core).
8. Connect the connector (black portion) of
Power Supply Harness 2 (without core) to the
copier.
9. Reinstall the rear Cover of each unit.
I-81
NOTE
Di251/Di351