Minolta Di251 Service Manual page 167

Rev. 11..0.0/03.01
5. Install the Bracket with care not to wedge the
Harness connected.
Accessories:
Screw .................. 2
Make sure that the tabs on the base plate of the
Paper Feed Unit fit into the slits in the bottom of
the Bracket.
6. Accessing through the hole in the Bracket,
connect the connector (white portion) of
Power Supply Harness 1 (with a core).
7. Connect the connector (black portion) of
Power Supply Harness 1 (with a core) to the
copier.
The connector of Power Supply Harness 1 (with
a core) may be connected to any one of the
receptacles on the copier.
8. Reinstall the rear Cover of each unit.
9. Reinstall the connector cover of the copier.
I-79
NOTE
NOTE
Di251/Di351