Minolta Di251 Service Manual page 115

Rev. 11..0.0/03.01
Check that the glass holding plates located (at
two places) in the rear of the Original Glass are in
contact with the surface of the Original Glass.
9. Pressing the Glass support toward the
Original Glass install the Glass support at the
location shown (screw 3×6mm Black).
Use the Glass Support furnished with the
ADF.
10. Press ADF Glass Assy up against the Glass
support and secure it in position (two screws).
Use the screws that have been removed in
step 4 to secure the assy in position.
Use the ADF Glass Assy furnished with the
ADF.
11. Install the Original Cover brackets at the
locations shown (one screw each).
Use the screw which has been removed in
step 3 for A.
Use the screw contained in the ADF for B.
(Use the screw furnished with the ADF for B.
12. Reinstall the covers which have been
removed.
I-27
NOTE
Di251/Di351