1.9.3
Installing the Horizontal Transport Unit
Rev. 11..0.0/03.01
1. Cut off the (three) treaded collars from the
Exit Rolls of the copier.
2. Fit the Horizontal Transport Unit mounting
base to the copier.
Ensure that the protrusions (at two places) on the
backside of the mounting base fit into the holes
(at two places) in the copier.
3. Mount the Horizontal Transport Unit on the
exit section of the copier.
4. Open the cover of the Horizontal Transport
Unit and fit the shaft of the Horizontal
Transport Unit into position as illustrated.
5. Make sure that the gears on the Horizontal
Transport Unit and the Finisher are in positive
engagement with each other. Then, secure
the Horizontal Transport Unit with the lock
lever.
Install the Horizontal Transport Unit, making sure
that the gears are in positive engagement.
I-53
NOTE
NOTE
Di251/Di351