Minolta Di251 Service Manual page 219

(4) Edge Erase
<Leading>
Requirement
A
NOTE
• This adjustment must be made when the PH Unit has been replaced and after Registra-
tion (CD/FD) (Printer) has been made.
Adjustment Procedure
1. Call the Tech. Rep. Mode to the screen.
2. Touch "Tech. Rep. Choice" and "Printer", in that order.
3. Touch "Edge Erase" and "Leading" in that order to call up the Leading Edge Erase
adjustment function.
4. Press the Clear key to clear the current setting value.
5. Enter the new setting value from the 10-Key Pad.
Setting Instructions
To make the edge erase width (width A) smaller, decrease the setting value.
To make the edge erase width (width A) greater, increase the setting value.
Setting Value
6. Touch "END" to validate the setting value.
NOTE
• Be sure to touch "END" to return to the normal operating mode. If the Panel Reset key is
used, the previous setting remains valid.
Set the erase width on the leading edge of paper
(width A) in the range between 0 and 5 mm.
1171D003AA
1171D003AA
4011P299CA
Adjust Mode
Edge Erase/Leading
Setting Range
0 to 5
Use to clear
setting value.
Use to enter setting value.
1167D069AA