Minolta Di251 Service Manual page 212

4011D077AB
(3) Remove the Fusing Roller Thermistor, Fusing Roller Hearter Lamp Fuse, and
Fusing Roller Thermostat
1. Remove the Fusing Unit
24. Remove one shoulder screw and the gear.
25. Snap off one retaining ring E type and remove
the gear assy, gear, and spring.
NOTES
• Study the illustration for how the spring is installed.
• After the spring has been installed, move the gear
assy in the direction of the arrow to make sure that
it is returned by the tension of the spring.
4011D078AA
26. Snap off one retaining ring and remove one
washer and one wave washer.
27. Remove one bearing each at the front and rear
and then remove the Left Fusing Roller.
4011D079AA
2. Remove three cord holder.
3. Remove two screw and the Holder Assy.
4011D080AB
4. Remove one screw and the Fusing Roller Ther-
mistor.
5. Remove two screws and the Fusing Roller Heater
Lamp Fuse.
6. Remove two screws and the Fusing Roller Ther-
mostat.
4011D081AA
D-31