Minolta Di251 Service Manual page 210

4011D066AA
6. Remove the harness from the Rear Cover.
7. Remove two screws and the Rear Cover.
8. Remove one screw and the lamp holder in the
rear.
4011D068AB
9. Remove one screw and the lamp holder at the
front. Then, slide out the Fusing Roller Heater
Lamp.
4011D069AA
10. Remove the harness from the harness guide and
edge cover.
11. Remove one screw, one shoulder screw, and the
Paper Exit Cover Assy.
12. Remove three screws, Coupling Gear Assy, and
gear.
13. Remove three screws and the Drive Frame Assy.
14. Unhook the spring to free the Rear Pressure
Lever Assy.
4011D070AB
15. Remove two screws and the Lever Assy.
16. Unhook the spring to free the Front Pressure
Lever Assy.
17. Snap off one retaining ring E type and remove
the idle lever.
4011D071AB
D-29