Minolta Di251 Service Manual page 220

<Trailing>
Requirement
1171D004AA
NOTE
• This adjustment must be made when the PH Unit has been replaced and after Registra-
tion (CD/FD) (Printer) has been made.
Adjustment Procedure
1. Call the Tech. Rep. Mode to the screen.
2. Touch "Tech. Rep. Choice" and "Printer", in that order.
3. Touch "Edge Erase" and "Trailing" in that order to call up the Trailing Edge Erase adjust-
ment function.
4. Press the Clear key to clear the current setting value.
5. Enter the new setting value from the 10-Key Pad.
Setting Instructions
To make the edge erase width (width A) smaller, decrease the setting value.
To make the edge erase width (width A) greater, increase the setting value.
4011P299CA
6. Touch "END" to validate the setting value.
NOTE
• Be sure to touch "END" to return to the normal operating mode. If the Panel Reset key is
used, the previous setting remains valid.
Set the erase width on the trailing edge of paper
A
(width A) in the range between 0 and 5 mm.
Adjust Mode
Edge Erase/Trailing
1171D004AA
Setting Value
D-39
Setting Range
0 to 5
Use to clear
setting value.
Use to enter setting value.
1167D069AA