Paper Size Setting - Minolta Di251 Service Manual

1.11.5

Paper Size Setting

Side edge guide plate
Di251/Di351
5. Remove the connector cover and Bracket
from the cassette and connect the relay
harness of the large capacity cabinet to the
cassette.
6. Install the Bracket.
7. Remove the connector cover from the copier.
8. Connect the connector of Power Supply
harness to the copier.
If the Power Supply harness cannot reach the
copier, add the extra harness enclosed to the
Powe Supply harness.
The connector of the P. S. harness can be
connected to any receptacle.
9. Reinstall all covers into positions.
The initial setting is for A4C.
1. Push in the front and rear edges of the trays
as far as they will go.
2. Change the positions of the rear and side
edge guide plates shown in the figure to
adjust the paper size. (One screw in each
location.)
Remove the rear edge guide plates when
adjusting the size to Letter C.
Make sure that the bottom part of the side edge
guide plate is inserted into the slot securely.
I-72
NOTE
NOTE
Rev. 1.1.0.0/03.01