Di251/Di351
5. Place the shift tray unit onto the mounting
frame as shown.
6. Remove the dummy connector from the
copier harness and plug in the copier harness
at the rear of the unit.
Install the shift tray unit front end so the pin
passes through the hole in the part indicated by
the arrow.
Make sure that the harness is plugged in
correctly and that the harness does not become
caught between the shift tray unit and the copier
7. Use an accessory screw (4 x 8 mm) to secure
the shift tray unit at the front.
8. Press on the decorative cover.
I-18
NOTE
Rev. 1.1.0.0/03.01