1.8.16
Checking the Position of the Single Feed Copy
A
B
4 1mm
1.8.17
Adjusting the Position of the Single Feed Copy
1.8.18
Securing the stoppers
Rev. 11..0.0/03.01
Check the paper to see how many mm its rear
edge deviates in the "A" or "B" direction with
reference to a line 4.0 mm to the front of the end
face of the FD Scale.
Allowable deviation : 4.0 ± 1.0 mm
Move the Guide Plate to the front or back as
necessary to meet the above requirements.
Less than 3.0 mm : To the front
More than 5.0 mm : To the back
Remove the shoulder screws (one each at the
right- and left-hand side) in the rear of the copier
and tighten these shoulder screws into the
corresponding upper holes.
I-47
Di251/Di351