1.4.2
Job tray installation
Rev. 11..0.0/03.01
1. Remove the panel from the front side of the
copier.
2. Remove the rear paper exit cover (1 screw)
and free the harness that is attached to the
backside of the cover.
Make sure that the harness does not fall inside
the main unit.
3. Cut off the treaded tires from only the two Exit
Rolls on both sides of the machine.
4. Use two accessory screws (4 x 8 mm) to
secure the mounting frame.
I-13
NOTE
Di251/Di351