Concluding Steps; Replacing The Front Usb Cable; Required Tools; Preliminary Steps - Fujitsu PRIMERGY TX100 S3 Maintenance Manual

Cabling

15.2.4 Concluding steps

Perform the following procedures to complete the task:
Ê Close the side cover as described in section
page 58.
Ê Reconnect the AC power cord to the power supply unit and secure it with a
cable tie as described in section
page 59.
15.3

Replacing the front USB cable

15.3.1 Required tools

Preliminary and concluding steps:
●
– Phillips PH2 / (+) No. 2 screw driver
Replacing the power cable: tool-less
●

15.3.2 Preliminary steps

Before replacing the power cable, perform the following steps:
Ê Shut down the server as described in section
page 42.
Ê Remove the AC power cord from the cable tie and disconnect it from the
system as described in section
Ê Open the side cover as described in section
page 45.
Ê Remove the HDD cage as described in section
on page 61.
334
"Connecting the server to the mains" on
"Disconnecting power cord" on page
Upgrade and Maintenance Manual
"Installing the side cover" on
"Shutting down the server" on
"Removing the side cover" on
"Removing the HDD cage"
43.
TX100 S3