Replacing A 3.5-Inch Hdd; Required Tools; Preliminary Steps - Fujitsu PRIMERGY TX100 S3 Maintenance Manual

Hard disk drives
7.4

Replacing a 3.5-inch HDD

Customer Replaceable Units (CRU)
Average task duration: 5 minutes
V
CAUTION!
All HDDs must be uniquely identified so that they can be reinstalled in
their original mounting locations later. If this is not done, existing data can
be lost.
7.4.1

Required tools

Preliminary and concluding steps: tool-less
●
Replacing a 3.5-inch HDD: tool-less
●
7.4.2

Preliminary steps

Before replacing a 3.5-inch HDD, perform the following steps:
Ê Shut down the server as described in section
page 42.
Ê Remove the AC power cord from the cable tie and disconnect it from the
system as described in section
Ê Open the side cover as described in section
page 45.
Ê Locate the defective HDD as described in section
component" on page
Only applicable for removing intact HDDs:
Ê Before removing a non-defective HDD, put the drive into "Offline" mode
using your RAID configuration software.
124
"Disconnecting power cord" on page
41.
Upgrade and Maintenance Manual
"Shutting down the server" on
"Removing the side cover" on
"Locating the defective
43.
TX100 S3