Required Tools; Preliminary Steps - Fujitsu PRIMERGY TX100 S3 Maintenance Manual

System board and components

14.2.2.1 Required tools

Preliminary and concluding steps: Phillips PH2 / (+) No. 2 screw driver
●
Removing the system board:
●
– Phillips PH2 / (+) No. 2 screw driver
Removing the TPM:
●
– Thin slotted screw driver (2 x 0.4 mm)
(*)
For the Japanese market:
– Dedicated TPM screw driver (CWZ8291A)

14.2.2.2 Preliminary steps

Before removing the TPM, perform the following steps:
Ê Before removing the TPM, it is necessary to remove BitLocker-protection
from the computer and to decrypt the volume.
Ask the system administrator to turn off BitLocker-protection using the
BitLocker setup wizard available either from the Control Panel or Windows
Explorer:
Ê Open Bitlocker Drive Encryption by clicking the Start button, clicking
Control Panel, clicking Security, and then clicking Bitlocker Drive
Encryption.
I
Administrator permission required If you are prompted for an
administrator password or confirmation, type the password or
provide confirmation.
Ê To turn off BitLocker and decrypt the volume, click Turn Off BitLocker, and
then click Decrypt the volume.
I
Decrypting the volume may be time-consuming. By decrypting the
volume, all of the information stored on that computer is decrypted.
For further information on how to disable BitLocker drive encryption,
please refer to the Microsoft Knowledge Base.
Fujitsu service partners will find additional information (also available
in Japanese) on the Fujitsu Extranet web pages.
298 Upgrade and Maintenance Manual
(*)
TX100 S3