Required Tools - Fujitsu PRIMERGY TX100 S3 Maintenance Manual

The TPM is activated in the system BIOS.
V
CAUTION!
– Before replacing the system board, ask the customer whether TPM
functionality is used.
– If the customer is using TPM functionality, remove the TPM from the
old system board and install it on the new system board.
Advise your contact persons that they must provide you with TPM
backup copies. For security reasons, the TPM must be restored / re-
saved by the customer. After installing a new system board the TPM
must be enabled. You may not clear the TPM data.
If the contact persons DO NOT have a backup copy available, inform
them that replacing the TPM will cause to lose all data.

14.3.1 Required tools

Preliminary and concluding steps:
●
– Phillips PH2 / (+) No. 2 screw driver
Replacing the system board:
●
– Phillips PH2 / (+) No. 2 screw driver
Replacing the system board:
●
– Magnifying glass for inspecting socket cover springs (recommended)
If a TPM is installed:
– Bit screw driver
– TPM bit insert
– thin slotted screw driver (
(*)
For the Japanese market:
– Dedicated TPM screw driver (CWZ8291A)
– TPM module fixing tool (S26361-F3552-L909)
TX100 S3
(*)
2 x 0.4 mm)
Upgrade and Maintenance Manual
System board and components
(*)
305