Accessible drives
12.4
Replacing accessible drives
Upgrade and Repair Units (URU)
Average task duration: 15 minutes
12.4.1 Required tools
Preliminary and concluding steps: tool-less
●
Removing accessible drives: tool-less
●
12.4.2 Preliminary steps
Before replacing an accessible drive, perform the following steps:
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê Remove all backup and optical disk media from backup and optical disk
drives as described in section
page
70.
Ê Verify if your backup software solution requires preparative configuration
before starting the procedure as described in section
configuring the backup software solution" on page
Ê Shut down the server as described in section
page
42.
Ê Remove the power cord from the cable tie and disconnect it from the system
as described in section
Ê Bring the server to its horizontal position.
Ê Open the side cover as described in section
page
45.
266
69.
"Removing backup and optical disk media" on
"Disconnecting power cord" on page
Upgrade and Maintenance Manual
"Disabling BitLocker
"Verifying and
71.
"Shutting down the server" on
43.
"Removing the side cover" on
TX100 S3