Removing Expansion Cards; Required Tools; Preliminary Steps - Fujitsu PRIMERGY TX100 S3 Maintenance Manual

Expansion cards and backup units
9.2.2

Removing expansion cards

Upgrade and Repair Units (URU)
Average task duration: 5 minutes
9.2.2.1

Required tools

Preliminary and concluding steps: tool-less
●
Removing expansion cards: tool-less
●
9.2.2.2

Preliminary steps

Before removing an expansion card, perform the following steps:
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê Shut down the server as described in section
page 42.
Ê Remove the AC power cord from the cable tie and disconnect it from the
system as described in section
Ê Remove all external cables from the expansion card to be removed.
Ê Bring the server to its horizontal position.
Ê Open the side cover as described in section
page 45.
Ê If applicable, disconnect internal cables from the expansion card.
156
69.
"Disconnecting power cord" on page
Upgrade and Maintenance Manual
"Disabling BitLocker
"Shutting down the server" on
"Removing the side cover" on
43.
TX100 S3