Fujitsu PRIMERGY TX100 S3 Maintenance Manual page 74

Basic software procedures
Ê Enter BIOS recovery mode using the onboard jumpers.
I
For detailed information on jumper settings, refer to section
settings" on page 343
Manual".
Ê Close the side cover as described in section
page 52.
Ê Connect the USB stick to the USB port.
Ê Connect the server to the mains as described in section
server to the mains" on page
Ê Press the On / Off button to start up the server.
The system will detect the USB stick and the BIOS recovery process will be
performed.
V
CAUTION!
Do not interrupt the BIOS upgrade process after it has started. If the
process is interrupted, the system BIOS may be permanently
corrupted.
Ê After completion of the flash process, shut down the server.
Ê Open the side cover as described in section
page 44.
Ê Disable BIOS recovery mode using the onboard jumpers:
I
For detailed information on jumper settings, refer to section
settings" on page 343
Manual".
Ê Close the side cover as described in section
page 52.
74
or the "System Board D3009 Technical
59.
or the "System Board D3009 Technical
Upgrade and Maintenance Manual
"Closing the server" on
"Connecting the
"Opening the server" on
"Closing the server" on
"Onboard
"Onboard
TX100 S3