Replacing The System Fan Module 1; Required Tools; Preliminary Steps - Fujitsu PRIMERGY TX100 S3 Maintenance Manual

System fan modules
8.2

Replacing the system fan module 1

Upgrade and Repair Units (URU)
Average task duration: 15 minutes
8.2.1

Required tools

Preliminary and concluding steps:
●
– Phillips PH2 / (+) No. 2 screw driver
Replacing the system fan module:
●
– Phillips PH2 / (+) No. 2 screw driver
8.2.2

Preliminary steps

Before replacing the system fan module, perform the following steps:
Ê Shut down the server as described in section
page 42.
Ê Remove the AC power cord from the cable tie and disconnect it from the
system as described in section
Ê Open the side cover as described in section
page 45.
Ê Remove the HDD cage as described in section
on page 61.
130
"Disconnecting power cord" on page
Upgrade and Maintenance Manual
"Shutting down the server" on
"Removing the side cover" on
"Removing the HDD cage"
43.
TX100 S3