Installing The New Tfm; Concluding Steps - Fujitsu PRIMERGY TX100 S3 Maintenance Manual

Figure 86: Removing the TFM
Ê Remove the three screws (1).
Ê Remove the TFM (2).
9.2.4.4

Installing the new TFM

Ê Install the new TFM as described in section
page 175.
Ê Connect the FBU adapter cable to the TFM as described in section
"Connecting the FBU adapter cable to the TFM" on page
Ê Install the expansion card as described in section
cards" on page
9.2.4.5

Concluding steps

Perform the following procedures to complete the task:
Check carefully the cable routing and close the cable clamps.
Ê
Ê Close the side cover as described in section
page 58.
Ê If applicable, connect external cables to the expansion card.
Ê Reconnect the AC power cord to the power supply unit and secure it with a
cable tie as described in section
page 59.
TX100 S3
150.
"Connecting the server to the mains" on
Upgrade and Maintenance Manual
Expansion cards and backup units
"Preparing the FBU" on
"Installing expansion
"Installing the side cover" on
178.
165